Install Plug-in

Before beginning installation, review the system requirements.

To install Dr.Web for Kerio Control firewall you must have the Administrator privileges.

Ensure to perform the following actions before installing Dr.Web for Kerio Control firewall:

1.Enable SSH on Kerio Control VMware Virtual Appliance:

•Open the terminal, press Alt+F2 on the terminal.

•Login as "root".

•Execute the following command: start-ssh.

2.Copy the drweb-kerio-control_9.0.0.[patch]-[build]~linux_x86.run archive and Dr.Web for Kerio Control firewall license key file on Kerio Control VMware Virtual Appliance.

To install Dr.Web for Kerio Control firewall

1.Allow execution of the drweb-kerio-control_9.0.0.[patch]-[build]~linux_x86.run archive (where [patch] is the number of patch, [build] is the number of program build, e.g., drweb-kerio-control_9.0.0.0-1401221455~linux_x86.run). You can use the following command:

# chmod +x drweb-kerio-control_9.0.0.[patch]-[build]~linux_x86.run

2.Execute the file by the command:

# ./drweb-kerio-control_9.0.0.[patch]-[build]~linux_x86.run

You can also specify the path to the license key file using the -k option:

# drweb-kerio-control_9.0.0.[patch]-[build]~linux_x86.run -- -k <path>

3.The drweb-kerio-control_9.0.0.[patch]-[build]~linux_x86 directory will be created. Then the installer will start.

4.To continue installation of Dr.Web for Kerio Control firewall enter Y or Yes (values are case insensitive) and press ENTER. This will start the installation of the components. Otherwise type N or No.

5.If you have not specify the path to the license key file when running the run-file, you will be asked to specify it.

6.The message informing about completing the installation of program components will open.