Configuring Scanner Settings

Via the Control Center, you can specify the following anti-virus check parameters:

•Dr.Web Scanner settings. This Scanner is launched by users on stations and cannot be remotely launched from the Control Center. But the administrator can remotely change its settings which will be transmitted and saved on stations.

•Dr.Web Agent Scanner settings. This Scanner is remotely launched from the Control Center and performs station check similarly to Dr.Web Scanner. Dr.Web Agent Scanner settings are presented as extended settings of Dr.Web Scanner and specified during the launch of stations anti-virus check.

Dr.Web Scanner Parameters Setup

1.In the main menu of Dr.Web Security Control Center, select Anti-virus network.

2.Click the name of a station or group in the hierarchical list of the opened window.

3.In the opened control menu in the Configuration section, select in the necessary operating system subsection the Scanner item. The Dr.Web Scanner settings window opens.

4.Specify necessary scan parameters. Description of Dr.Web Scanner parameters is given in the Manual for managing stations for corresponding operating system.

5.Click Save. Settings will be saved in the Control Center and transmitted to the corresponding stations.

Dr.Web Agent Scanner Parameters Setup

Dr.Web Agent Scanner parameters are specified during the launch of stations anti-virus check as described in the Launching Scan on Station section.

The list of Scanner settings sections which are available (+) or not available (–) depends on the mode of station scan launch and presented in the table below.

The list of Dr.Web Agent Scanner settings sections depending on the scan launch

Depending on the operating system of the stations on which the remote scan is launched, only those Dr.Web Agent Scanner settings are available which are supported by the station system.