To install Dr.Web Enterprise Agent in the background mode of the installer:
1.From the workstation, on which you want to install the anti-virus software, enter the network catalog of Agent installation located at the Server (by default, it is Installer folder) and run the drwinst programm.
By default, the drwinst instruction launched without parameters will use the Multicast mode to scan the network for Enterprise Servers and will try to install Agent from the first found Server.
|
When you use the Multicast mode to find active Servers, the Agent installation is performed from the first founded Server. If the pub-key is not fitted to the Server key, installation will be failed. In this case, expressly specify the Server address (as described below). |
The drwinst command may be used with switches:
◆If the Multicast mode is not used to detect the Server, it is recommended to specify a domain name for the Enterprise Server in the DNS service and use this name when installing the Agent:
drwinst <Server_DNS_name>
It is especially useful in case you would like to reinstall the Enterprise Server on a different computer.
◆You can expressly specify the Server address as follows:
drwinst 192.168.1.3
◆Using the -regagent switch during the installation will allow you to register the Agent in the Add or Remove Programs list.
◆To launch the installation in the graphical mode, use the -interactive parameter.
|
The complete list of Network Installer parameters is describe in the Appendix H4. Network Installer. |
2.After the installation, the software of Enterprise Agent is installed on your computer (anti-virus package is not installed yet).
3.After the station has been approved at the Server (if it is required by Enterprise Server settings), the anti-virus package will be automatically installed.
4.Restart the computer on Agent request.