One or several Proxy servers can be included into the anti-virus network.
When choosing a computer where the Proxy server should be installed, consider that it should be accessible from all networks and segments which require data redirection between them.
|
To install the Proxy server, you must have administrator rights on this computer. |
Below is described the installation of the Proxy server for Windows OS. The set and the order of steps may somewhat differ depending on the distribution file version.
To install the Proxy Server on a computer operated by Windows OS
1.Run the distribution file. A window of Installation Wizard with information about the program to be installed will be opened. Click Next.
2.A window with the text of the license agreement will be opened. You should read and accept the agreement. To continue the installation, in the bottom part of the window select I accept the terms of the license agreement and click Next.
3.A window for changing the default installation folder (C:\Program Files\DrWeb Enterprise Proxy) will be opened. If necessary, click Change and specify the installation folder. Click Next.
4.A window for setting Proxy server parameters will be opened:
◆In the Listen to field, specify an IP address, which will be "listened" by the Proxy server. By default, it is any (0.0.0.0) value, which means "listen" to all interfaces.
◆In the Port field, specify a port, which the Proxy server listens. By default, it is 2193 port or 23 port for NetBIOS protocol.
◆In the Protocol drop-down list, select a type of the protocol for accepting incoming connections by the Proxy server.
◆Set the Enable discovery flag to enable the Server imitation mode. This mode allows Network scanner to detect the Proxy server as an Enterprise Server.
◆In the Multicast group, specify an IP address of a multicast group, in which the Proxy server is included. Specified interface will be listened by the Proxy server for interaction with Network installers during active Enterprise Servers searching.
◆In the Redirect to section, specify an address or the list of addresses of Enterprise Servers, where the connection established by the Proxy server should be redirected to.
After you specify Proxy server settings, click Next.
5.A window with information, that the Proxy server is ready to install, will be opened. Click Install.
6.Once the installation is complete, click Finish.
After installation you can change operation parameters of the Proxy server. For this you can use the drwcsd-proxy.xml configuration file which is located in the Proxy server installation folder. Parameters of the configuration file are given in Appendix G4.
Package-based installation of the Proxy Server on a UNIX system-based OS
Use the following command:
◆for FreeBSD OS:
pkg_add <distribution_file_name.tbz>
◆for Solaris OS:
bzip2 -d <distribution_file_name.bz2> and then:
pkgadd -d <distribution_file_name>
◆for Linux OS:
◆for Debian OS and Ubuntu OS:
dpkg -i <distribution_file_name.deb>
◆for rpm distribution kits:
rpm -i <distribution_file_name.rpm>
Also, there are so-called generic packages, which can be installed on any Linux-based system including those which are not on the list of supported systems. They are installed by means of the installer included in the package:
tar -xjf <distribution_file_name.tar.bz2>
After that you need to move all unpacked folders into the root directory.
|
In the course of the installation for FreeBSD OS an rc script /usr/local/etc/rc.d/0.dwcp-proxy.sh will be created. ◆To manually stop the Proxy server, use the command: /usr/local/etc/rc.d/0.dwcp-proxy.sh stop ◆To manually start the Proxy server, use the command: /usr/local/etc/rc.d/0.dwcp-proxy.sh start
During the installation for Linux OS and Solaris OS, an init script (/etc/init.d/dwcp-proxy) for the launching and termination of the Server will be created. |