|
To connect the Agent to other Enterprise Server, you must perform all actions at the station with the administrative rights. |
To connect Dr.Web Enterprise Agent to other Dr.Web Enterprise Server, do the following:
1.If the drwcsd.pub public key of the new Server does not match with the public key of the old Server, you must change this key at the Agent:
1.1. If the SelfPROtect component is active on the station with the Agent, disable it via the Agent context menu (to do this, you must have administrative rights at the station and rights for disabling the component, which are set at the Server).
1.2. Copy the drwcsd.pub public key from the new Server to the Agent installation directory.
2.Change the Server address at the Agent settings:
◆Via the Dr.Web Control Center (for the old Server): Network option of the main menu → Dr.Web Enterprise Agent for Windows option of the control menu → Network tab → Server field.
◆At the station: Settings submenu of the Agent context menu → Connection option → Server field.
3.Set the station to the Newbie (reset parameters of connection with the Server):
◆Via the Dr.Web Control Center (for the new Server): Administration option of the main menu → Dr.Web Enterprise Server Configuration option of the control menu → General tab → set the Reset unauthorized to newbie flag.
◆At the station: Settings submenu of the Agent context menu → Connection option → Newbie button.
4.Restart the Agent service (see the Dr.Web Enterprise Agent section).
If rights for changing the Dr.Web Enterprise Agent settings are not allowed for the station, use the following procedure:
1.If the drwcsd.pub public key of the new Server does not match with the public key of the old Server, you must change this key at the Agent:
◆If the SelfPROtect component is active on the station with the Agent, disable it via the Agent context menu (to do this, you must have administrative rights at the station and rights for disabling the component, which are set at the Server).
◆Copy the drwcsd.pub public key from the new Server to the Agent installation directory.
2.Run the following command to specify the Agent settings:
drwagntd -save <new_server_ip> |
where <new_server_ip> is the address of a new Server, to which the Agent must be connected. The address must be set according to the The Specification of Network Addresses.
3.Restart the Agent service (see the The Dr.Web Enterprise Agent section).